Ecu flash programming
![ecu flash programming ecu flash programming](https://webgener.co/wp-content/uploads/2019/03/Car-ECU-Flash-Reprogramming.jpg)
This car has a check engine light that meets a flash so we'll type in the box flash for drivability issue as per Technical Service Bulletin TSB, and you'll click Flash ECU button. Selecting that you understand that you're flashing will ask you to select a category of why this particular vehicle needs to flash, I choose Service Information/documentation led to re-flash the component. Right side there's an arrow select that, and it'll bring you to the module flashing screen, where you'll want to click on the consent checkbox. Click on the tab "All Flashes" at the top bring up the only flash that's available for this car. Once the Micropod II identified in wiTECH 2 click anywhere in the gray box area, it'll bring up the network topology. For this test, we have in our programming bay a 2018 Dodge RAM 1500 PICKUP 5.7L HEMI. Once your vehicle's all set up to flash, don't forget to connect the external battery maintainer.
ECU FLASH PROGRAMMING HOW TO
In this document, we will explain how to do flash programming using wiTECH 2.
![ecu flash programming ecu flash programming](http://www.autelscanner.org/wp-content/uploads/2016/03/kess-v2-software-dispaly-1.jpg)
wiTECH 2 will start to identify the vehicle based on VIN and the installed components in the vehicle network, which will bring up the network topology. It can be seen then that the AUTOSAR specification relies strongly on UDS to perform flash reprogramming.Flash programming using wiTECH 2.0 software, connect the Micropod II interface to OBD II / DLC port in the car.